#106627 - FLUX VAPOR WATERPROOF SPEED CONTROL

Get increased weatherproof performance with brushless or brushed motors with the Flux Vapor electronic speed controller from HPI! The standard speed controller in the updated Sprint 2 Flux kits, the Flux Vapor features real Deans plugs for low-loss connectivity and sturdy brass tube connectors for connecting 12 gauge wires to any brushless motor.

With a range of custom tuning possibilities, this is the ideal upgrade for any car or truck using brushed motors! FEATURES:

• 6-7 Cell NiMH/ NiCd or 2S/3S LiPo
  Please Note: Vektor Motor Limit on 3S is 4800kV
• Waterproof!
• Can handle 40% MORE power than Motiv ESC Ultra low resistance (.0007 ohms / phase)
• Sensorless technology eliminates additional sensor wiring and complexity
• Lithium-Ion Compatible. **Programmable Lithium under-voltage cutoff protects delicate lithium packs from over-discharge
• High performance cross-cut aluminum heat sink
• Smooth startup and run with sensorless motors (Patents Pending)
• Linear Torque Braking allows better control on corner entry
• Connect to your PC using the #100573 Castle Link for super-easy customizations!

NOTE: Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts. 

Download PDF instructions for #106627 (4.1 MB)